Tolerances for nominal inside diameter of welding ends of weld neck flange and socket weld flange with smaller bore. (a) For figures 7 (Bevel for wall thickness from 5 mm to 22 mm), figure 8 (greater than 22 mm) and figure 4 (Straight Hub Welding Flange) in ASME B16.5.
Feb 16, 2016 · Flange - Long Weld Neck, ANSI Class 150, ASME B16.5, 1/16" Raised Face (in) Written by Matt Milbury on 16 February 2016. Posted in Standard Connection Flange Datasheets. Dimensions to ASME B16.5 - Pipe Flanges and Flanged Fittings:NPS 1/2 through NPS 24 Metric/Inch Standard. Bolt circle diameters are 1/8 inch larger than bolt diameter. flange face surface finish - Sunny SteelThe ASME B16.5 code requires that the flange face (raised face and flat face) has a specific roughness to ensure that this surface be compatible with the gasket and provide a high quality seal. A serrated finish, either concentric or spiral, is required with 30 to 55 grooves per inch and a resultant roughness between 125 and 500 micro inches.
The ASME B16.5 code requires that the flange face (raised face and flat face) has a specific roughness to ensure that this surface be compatible with the gasket and provide a high quality seal. A serrated finish, either concentric or spiral, is required with 30 to 55 grooves per inch and a resultant roughness between 125 and 500 micro inches.
Your email address will not be published.*